AC Repair in Indianapolis, IN. Fast, Honest, and Done Right.

The compressor is the heart of your cooling system, and when it starts to fail, you’ll usually notice a combination of symptoms: warm air blowing from vents even though the system is running, a hard-starting AC that takes several attempts to turn on, unusual grinding or chattering sounds from the outdoor unit, and circuit breaker trips when the system tries to start. A failing compressor is one of the more serious AC repairs, and early diagnosis gives you more options. If you’re seeing these signs (in Dayton, Indianapolis, or anywhere in our service area) call for a diagnostic visit before the compressor fails completely.

Yes, and it’s more common than most homeowners expect. A severely clogged filter restricts airflow through the evaporator coil. When airflow drops too low, the coil gets too cold and freezes over. A frozen coil can cause the system to stop cooling entirely, and if it runs long enough in that state, it can damage the compressor. If your AC suddenly stops cooling, check the filter first. If it’s visibly clogged, replace it and give the system a few hours to thaw before running it again. If cooling doesn’t return, call Bassett Services.

Refrigerant leaks most often develop from vibration-related wear on the refrigerant lines or connections over time, corrosion caused by formic acid produced when formaldehyde in indoor air reacts with copper components, or physical damage to the lines. Signs include ice forming on the refrigerant lines or indoor coil, reduced cooling capacity, hissing sounds near the outdoor unit, and higher-than-normal energy bills. Refrigerant is not something that gets topped off: the leak must be located and repaired before the system is recharged. Our technicians handle both.

An AC that repeatedly trips the breaker is signaling an electrical problem that needs professional attention. Common causes include a failing compressor drawing too much current, a short circuit within the unit, a bad capacitor overloading the start sequence, or a worn breaker unable to handle the normal electrical load. Reset the breaker once. If it trips again, turn the system off and call for service.

Loud or unusual AC noises are almost always a sign something needs attention. Banging or clanking often means a loose or broken part. Squealing points to a failing belt or motor bearing. Buzzing can indicate an electrical issue. Grinding usually means the motor is wearing out, and a high-pitched compressor noise in particular is a sign to turn the system off immediately and call for service, as it can indicate a pressure condition that is damaging to the equipment and potentially unsafe.

Water leaking from your AC is usually caused by a clogged condensate drain line, a frozen evaporator coil that’s thawing, or a disconnected or cracked drain pan. The most common cause is a clogged drain, which is a straightforward fix during a service call. If the dripping is significant or ongoing, check for water damage around the air handler and call for service before the situation causes structural damage.

Basic maintenance tasks are safe: changing air filters, clearing debris from the outdoor condenser, and flushing condensate drain lines. Anything involving electrical components or refrigerant requires a licensed technician: EPA regulations prohibit unlicensed refrigerant handling, and opening a control panel without proper training creates a real safety risk. Incorrect DIY repairs also void most manufacturer warranties.

Before calling for service, check three things: your thermostat (confirm it’s set to COOL, below room temperature, with fresh batteries), your circuit breaker (reset it once, if it trips again immediately, stop and call), and your air filter (a severely clogged filter can shut the system down; replace it and give the unit 30 minutes to recover). If none of those resolve it, call Bassett, running a system when something is seriously wrong often turns a minor repair into a major one.

A useful starting point is the $5,000 rule: multiply your system’s age in years by the estimated repair cost. If that number comes in well above $5,000, replacement is typically the smarter financial move. Systems under ten years old with a modest repair bill are almost always worth fixing; systems 12 years or older facing a significant repair, rising energy bills, or repeat service calls are worth comparing against the cost of a new unit. Bassett technicians provide an honest assessment of both options with full pricing for each, in every market we serve.

Most common AC repairs across our Indiana and Ohio service area range from $150 to $650 depending on the part and labor involved; major repairs like compressor replacement can run higher. Bassett Services provides upfront pricing after diagnosing the issue, so you know the full cost before any work begins. No hidden fees, no exceptions by city.

Most standard repairs are completed in a single visit, typically 1 to 3 hours depending on the issue. If a part needs to be ordered, we’ll give you a realistic timeline upfront and schedule a return visit as quickly as possible.

Yes. Bassett Services technicians are trained to diagnose and repair all major AC brands and system types, including Carrier, Trane, Lennox, Rheem, and Goodman, and we’re a proud Bryant dealer. We stock commonly needed parts on our trucks to resolve most repairs in a single visit, whether you’re in Columbus, Dayton, Indianapolis, Carmel, Lewis Center, Newark, or Zionsville. RELATED SERVICES

Yes. Bassett Services offers 24/7 emergency AC repair throughout Columbus, Dayton, Newark, and Lewis Center, Ohio, and Indianapolis, Carmel, and Zionsville, Indiana. We dispatch certified technicians day or night, including weekends and holidays. Call the number for your area and we will confirm your service window immediately. We do not leave emergency callers waiting until the next business day.